Many parameters in PCB design seem simple. But in practice they are far more complex than they appear at first glance. Saar Drimer, electronics designer and technical editor, explains these parameters with examples and shows potential pitfalls. In this 6-part series, Saar also gives valuable tips for a good PCB design that any manufacturer can produce.
Enjoy your reading.
The outline must have a closed shapeNormally, the centre of the line thickness of the outer contour is used as the actual outline of the PCB. This sounds simple, but this is where the mistakes lie. |
 |
Courtyards create safety spacing for the componentsThe courtyard defines a safety spacing around a component similar to a fence. In this article, Saar shows how to use courtyards effectively. |
 |
Annular rings: the correlation of hole diameter and copper padIn practice, we have two diameters for the plated-through hole: the actual hole diameter and the finished hole diameter. |
 |
Keepout areas protect against costly errorsKeepouts are areas on the PCB where we instruct our design tool to enforce restrictions on what is and is not allowed in that area. |
 |
Fiducials must be reliably detectedThe geometry and placement of the fiducials determines the reliability of the PCBs to be produced. Here are our tips. |
 |
Solid copper fills are the first choiceThis article explains the mechanical and manufacturing aspects of copper surfaces for PCB designers. |
 |
